:  Jul 14, 2004


















  : Make sure the bush is correctly aligned.

:
  Take note of the fitted position of the bush.

.
  : Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.

. Remove the exhaust system.

. Using a suitable jack, support the axle assembly.

. Remove the axle carrier bushing heat shield.
  Remove the two retaining bolts.




.
  : The bolts must only be used once.

Remove the axle carrier.
  Remove and discard the three bolts retaining the axle carrier to the axle.
  Remove the axle carrier bushing bolt.




. :
  Take note of the fitted position of the bush.

Using the special tools, remove the axle carrier bushing.



.
  : Make sure the bush is correctly aligned.

Using the special tools, install the axle carrier bushing.



. Install the axle carrier.
  Tighten the M14 bolt to 105 Nm (77 lb.ft).
  Tighten the new axle carrier bracket bolts to 80 Nm (59 lb.ft), then a further 60 degrees.

. Install the axle carrier bushing heat shield.

. Remove the axle support.

. Install the exhaust system.